How To Set The Unit - BoomToneDJ OctaBeam LED Mode D'emploi

5. How To Set The Unit

To select any of the given functions, press the MENU button up to the required one is shown
on the display. Select the function by ENTER button and the display will blink. Use DOWN
and UP button to change the mode. Once the required mode has been selected, press the
ENTER button to setup or it will automatically return to the main functions without any
change after idling 10 seconds. To go back to the functions without any change press the
MENU button. The main functions are shown below:
CODE
MODE 1
MODE 2
MODE 3
MODE 4
Auto mode
Sound mode Slow working without sound. Light is off when no sound
6. How to control the fixture
There are two ways to control the fixture
A. Universal DMX controller
B. Master/Slave operation
A. Universal DMX controller
The fixture can be set the DMX address remotely by universal DMX controller. First, you
need to programming two scenes into a chase, and then link the fixtures to the universal
DMX controller. When you run the chase, all the fixtures of the chain will be set the series
DMX address automatically. The fixture uses four channels. Please refer to the following
diagram to set the address for the first four units.
B. Master/Slave operation
The fixture will allow you to link 16 fixtures together and operate without a controller. In
MENU---UP---DOWN---ENTER(SAVE)
8001~8551
3001~3511
AU 1~AU 9
SOUD
Speed from slow to fast
10
8DMX CHANNEL MODE
3DMX CHANNEL MODE
AUTO WORKING
MUSIC ACTIVE