How To Set The Unit - BoomToneDJ Xtrem LED Mode D'emploi

5. How To Set The Unit

To select any of the given functions, press the MENU button up to the required one is shown
on the display. Select the function by ENTER button and the display will blink. Use DOWN
and UP button to change the mode. Once the required mode has been selected, press the
ENTER button to setup or it will automatically return to the main functions without any
change after idling 10 seconds. To go back to the functions without any change press the
MENU button. The main functions are shown below:
Button:
① MENU
② UP
③ DOWN
④ ENTER
LED:
⑤Signal indicator light of DMX
If the DMX signal was detected , the indicator light flashing.
⑥Signal indicator light of Slave
If the slave signal was detected , the indicator light flashing.
Note:
(1) In about ten seconds, if no buttons was pressed, the LED display will be off.
Press any button to turn the display on again.
(2)After pressing a button, all the parameters will be saved after a period of time .
(3)No matter what the program in which mode,once to detect the DMX or SLAVE
signal,the program will jump into DMX or SLAVE mode automatically. Then,if
DMX/SLAVE signal was disconnect, the program will return to the original mode.
To select the programming functions
Increase parameter
Reduce parameter
Enter submenu
10