Connection To The Audio System; Mains Connection; Inserting/Replacing The Remote Control Batteries - MC Crypt CMP-980USB DJ-CD Notice D'emploi

8. Connection to the Audio System

The CD player and all connected devices must be switched off when the power supply is connec-
ted.
To connect the outputs, use shielded cables only. The use of other cables might cause interfe-
rences.
To avoid distortions or mismatches which could damage the device, only connect devices with
the same connection type.
For this, observe also the connection information in the section "Technical Data".
OUTPUT connection (28)
Connect this output to a free RCA input of your amplifier/mixing console.
• The white RCA jack is the jack for the left channel.
• The red RCA jack is the jack for the right channel.

9. Mains Connection

The CD player and all connected devices must be switched off when the power supply is
connected.
Make sure that all electrical connections and connection cables between the different devices
and any extension cables comply with the regulations and the operating instructions.
• Connect the small device connection plug of the power line to the power connection (27) on the device.
• Plug the mains plug into a wall mains socket.
• The mains switch (1) is used to switch on and off the device.

10. Inserting/Replacing the Remote Control Batteries

Make sure that the batteries are not shorted, charged, opened or thrown into a fire. There is a danger
of explosion!
Old or used batteries can leak chemicals that can damage the device. Therefore if the device is
not to be used for a long time (e.g. storage), remove the batteries.
Leaking or damaged batteries can lead to caustic burning of the skin. Therefore, use suitable
protective gloves.
Make sure that the polarity is correct when inserting the batteries (pay attention to plus + and
minus –). Only use batteries of the correct size and the recommended type.
All batteries should be replaced at the same time. Mixing old and new batteries may cause the
batteries to leak which will result in damage to the device.
36