Hdcc72560; Connecting The Video Cable - Abus HDCC62560 Notice D'utilisation

3.2.

HDCC72560

Glue the drilling template provided where you intend to install the camera. Drill the required holes.
Twist the camera cap until the mark on the camera base plate and the groove of the camera cap are
aligned (see image 1). Remove the camera base plate using a flat object (e.g. a coin).
Use the wall plugs and screws provided to mount the camera base plate in place.
If the cable is to be routed through the side, do not fully mount the camera base plate until
the camera and the camera cap are in their place.
Place the camera on the camera base plate and lay the cable through the wall or side. Clip the camera
cap on and align the camera and camera cap.
Alignment
3.3.

Connecting the video cable

In order to transmit the HD-TVI video signal from the camera to an HD-TVI recorder, an RG59 type
coaxial cable with BNC connector (male) must be connected to the connection labelled 'TVI'. The cable
length to the next device must not exceed 500 m (RG6) or 300 m (RG59).
Please note that the camera's image transmission may be disrupted when laying cable
next to power lines or other conducting materials.
Recommendation:
Use TVAC25220 or TVAC25210 suppressor filters to minimise disruptions.
1. Rotation: 0–360°
2. Tilting: 0–75°
3. Panning: 0–360°
11
English