Control Panel Description - afx light FOG3000T Manuel D'utilisation

CONTROL PANEL DESCRIPTION

1. When the LCD displays "READY TO FOG"，push the FUNCTION button once，the LCD will display [INTERVAL
SET](this is to set the time interval between each emission). During this mode，user can set up the time interval of
the fog output by pushing buttons UP and DOWN (the time interval can be set from 1 to 200 seconds)
2. When the LCD displays "READY TO FOG" ，push the FUNCTION button twice, the LCD will display [DURATION
SET] (this is to set the continuous fog time).During this mode, user can set up the continuous fog time by pushing
UP and DOWN (the range of the output time can be set from 1 to 200 seconds)
3. When the LCD displays "READY TO FOG" ，push the FUNCTION button three times, the LCD will display
[TIMER OUT] (this is to set the fog output amount).Under this mode,user can set up the timer by pushing UP and
DOWN to adjust the fog output volume.(the range of the output can be set between 1% to 100% )
When the LCD displays "READY TO FOG" ，push the TIMER button will enable the user to initiate preset up
preferred timer mode. Machine will work according to the set up interval time,and amount to create the most
satisfactory fog.While the machine is under the operating mode,push TIMER button one more time will exit the timer
mode.
4. When the LCD displays "READY TO FOG" ，push the FUNCTION button four times, the LCD will display
[VOLUME OUT].Under this mode,user can Use UP and DOWN to adjust the output volume.(range from 1% to
100%).
When the LCD displays "READY TO FOG"， push the VOLUME button will enable the initiate output mode. While the
machine is still in operation, press the VOLUME button one more time to exit the direct fog mode.
Note:
This fog machine comes with the memory function; therefore the set up VOLUME does exist in the machine. This
can help to save some time for setting up. When the machine plugs in next time the set up will remain as the
pervious one unless you delete the record or reset.
5. When the LCD displays "READY TO FOG"，press the FUNCTION button six times, the LCD screen will display
[DMX 512].In this mode, the user can use the button UP and DOWN to set the DMX address.
6. The fog machine has one DMX channel. Value 0-5: turn off fog. Value 6-255: the fog output changes from
1%-100%.
7. When the LCD screen displays "READY TO FOG", keep pressing the MANUAL button to force the machine to
generate 100% full fog output. Once the MANUAL button is released, the machine stops fogging immediately.
© Copyright LOTRONIC 2014 FOG 3000T Page 4