Steba HF 1000 Mode D'emploi page 17

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

∙ Unwind the cable from the cable storage and plug it in. the device beeps and the
display shows - - - in blue.
∙ Pre-heat the device for 2 minutes, fill the basket up with food and insert it to the
device.
∙ Fill the basket up to ¾ in order to avoid any burns on the food and leave
space to turn the food.
∙ By pulling out the pot from the device to control the degree of doneness, the heat-
ing is interrupted, time is stopped too.
∙ After the time run out, take out the pot and place it on a heat resisting surface.
∙ By pressing the basket locking you can detach the basket and take out the food.
If the pot and the basket are used together to take out the food, for season-
ing etc., do not press the basket lockingIn order to achieve an even brown-
ing of the food, turn or shake the food. Do not use any metallic objects
for turning the food.
The pot and basket get very hot! Fill the basket only up to the max mark-
ing in order to avoid any burns on the food.
∙ Plug in the device, the panel flashes
∙ Press the power button, the display flashes and the device turns into stand-by
mode.
∙ Press the temperature button
temperature symbol is flashing.
∙ You can set the desired temperature with the buttons +/- from 80°C up to 190°C.
By keep pressing you enter the fast mode setting.
∙ Press the timer button
symbol is flashing.
∙ You can set the desired time with the buttons +/- from 00:01 up to 01:00.
∙ Press the start/stop button
∙ The display alternately shows the set temperature and the remaining time.
∙ During operation, the temperature and time can be changed by pressing the tem-
perature or timer button. The value shows can be changed with the +/- buttons.
∙ If the basket is pulled out of the device during operation, the timer stops and re-
starts again as soon as the basket is inserted again.
∙ 1 minute before the timer ends, the device beeps and the heating is switched off.
The ventilation turns off after 1 minute and the display shows "END".
∙ If the device is stopped with the start/stop button, the remaining time is shown
and start/stop flashes.
, the default setting 180°C is shown and the
, the default setting 15 minutes is shown and the timer
, the program starts running.
17

Publicité

Table des Matières
loading

Table des Matières