Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8. „Change battery" icon
9. Arrhythmia recognition
PC kit
With the additionally available accessory set 655.17,
consisting of a CD with PC software and a data-transfer
cable, you can evaluate your data extremely effectively.
You will find the installation instructions in the PC kit.
4. Prepare measurement
Inserting battery
• Push the cuff holder up-
wards at the rear of the
device until it locks into
place.
• Open the battery com-
partment lid
• Insert four AA 1.5 V
alkaline batteries. making
absolutely sure that you
insert them with the correct polarity as marked. Never use
rechargeable batteries.
• Replace the battery cover carefully.
If the battery change „
measurement is no longer possible and you must replace all
" is continuously illuminated,
the batteries. Once batteries have been removed from the
device, the time must be reset.
Used batteries do not belong in the household waste. You
are legally obliged to dispose of the batteries. Dispose of
them via your specialist electrical supplier or local collec ting
point for recyclable waste.
Note: Batteries containing pollutant sub-
stances are marked as follows: Pb = Battery
contains lead,
Cd = Battery contains cadmium, Hg = Battery
contains mercury.
Setting date and time
You should set the date and time without fail. Otherwise,
you will not be able to save your measured values correctly
with a date and time and to access them again later.
The time is displayed in the 24-hour format.
Tip: If you press and hold the "MEM" button, you can set
the values more quickly.
To set the date and time, proceed as follows:
• Move the touch screen activation switch to the "ON"
position.
• Press the "START/STOP" and "MEM" buttons simultane-
ously. The year display will start to flash. Set the year with
the "MEM" button and confirm with "START/STOP".
• Then set the month, day, hour and minutes and confirm
each setting with "START/STOP".
17
Publicité
Table des Matières
