Measurement Of Constructional Material Or Wood Moisture; Temperature Display; Pocket Lamp; Automatic Switch-Off - Powerfix Profi PBUH 1.5 A1 Mode D'emploi

Measurement of constructional material or wood moisture

♦ Switch the appliance on by pressing the ON/SET
♦ Before taking the fi rst measurement, check that the appliance is functioning
correctly. For this, use the test aid
measurement points marked as and .
♦ Press the measuring pins
lines on the display
♦ Now press the measuring pins
lines on the display
♦ When you arrive at the given value in both tests, the appliance is ready for use.
♦ Press the measuring pins
lines on the display
♦ To read the result for fi rewood, cardboard and construction timber, use the
left scale with the symbol
♦ To read the results for mortar, concrete and plaster, use the right scale with
the symbol
♦ If the measured value exceeds the maximum values of 2 % resp. 44 %, the
measurement lines start to blink.
♦ To minimise measurement errors, carry out comparative measurements at
several locations.

Temperature Display

♦ The temperature is indicated at the top of the display
♦ Press and hold the ON/SET
Celsius and Fahrenheit.

Pocket lamp

♦ Press and hold the button
♦ Press the button
Automatic switch-off
The appliance switches itself off automatically after approx. 30 seconds without
button activation. The automatic switch off is disabled when the LED
switched on.
PBUH 1.5 A1
. On the test aid
on the measurement points . All measurement
begin to blink.
on the measurement points . The measuring
should now be showing 19 % (+/- 1 %).
into the material to be tested. The measurement
show the moisture content.
.
.
button for 3 seconds to toggle between
for 3 seconds to switch the LED
once again to switch the LED
button.
there are four
.
on.
off .
is
GB
29