Elem Garden Technic THE6120RH Traduction Des Instructions D'origine page 19

Wait until the machine has come to a
standstill before placing it down.
Other persons and animals should remain at a
distance of 3metres or more when the machine is
being used. The operator is responsible for third
persons in the working area.
Never grasp the blade of the hedgecutter.
Children or persons unfamiliar with these
instructions must not operate the hedgecutter. Local
regulations may restrict the age of the operator.
Never cut a hedge while people, especially
children or pets, are nearby.
The operator or user is responsible for accidents
or hazards occurring to other people or their
property.
Do not operate the hedgecutter when barefoot or
wearing open sandals, always wear substantial
footwear and long trousers. The use of sturdy
gloves, non-skid footwear and safety glasses is
recommended. Do not wear loose clothing or
jewellery which can be caught in moving parts.
Thoroughly inspect the area where the
hedgecutter is to be used and remove all wires and
other foreign objects.
Prior to operation, check cutter blades, blade
bolts and cutter assembly for wear or damage. Do
not operate with a damaged or excessively worn
cutting device.
Check cable for damage before starting work and
replace if necessary. Keep cable away from heat, oil
and sharp edges.
Know how to stop the hedgecutter quickly in an
emergency.
Cut a hedge only in daylight or in good artificial
light.
Never operate the hedgecutter with defective
guards or without the guard in place.
Always ensure all handles and guards supplied
are fitted when using the hedgecutter. Never
attempt to use an incomplete hedgecutter or one
with an unauthorised modification.
Never hold the hedgecutter by the guard.
While operating the hedgecutter always be sure
of a safe and secure operating position at all times,
especially when using steps or a ladder.
Always be aware of your surroundings and stay
alert for possible hazards that you may not hear
whilst operating the hedgecutter.
Remove the plug from the socket:
– before checking, clearing a blockage or working
on the hedgecutter.
– after striking a foreign object, inspect the
hedgecutter for damage and make repairs as
necessary.
– if the hedgecutter starts to vibrate abnormally
check immediately.
Keep all nuts, bolts and screws tight to ensure
that the hedgecutter is always in a safe working
condition.
The hedgecutter should be stored in a dry, high or
locked up place out of the reach of children.
Replace worn or damaged parts for safety.
Do not attempt to repair the machine unless you
are qualified to do so.
Electrical Safety
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
The blades continue to move for a few
seconds after the hedgecutter is switched off.
Caution! Do not touch the moving blades.
Your machine is double insulated for safety and
requires no earth connection. The operating voltage
is 230 V AC, 50 Hz (for non-EU countries 220 V,
240 V as applicable).
Extension cords/leads should only be used if they
comply with H05VV-F or H05RN-F types.
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
WARNING: For your safety, it is required that the
plug attached to the machine is connected with the
extension cord.
The coupling of the extension cord must be
protected against splash water, be made of rubber
or coated with rubber. The extension cord must be
used with a cable strain relief.
The connection lead must be inspected for signs of
damage at regular intervals and may only be used if
in perfect condition.
Maintenance
Always wear gardening gloves when handling or
working near the sharp blades.
Examine the machine and replace worn or
damaged parts for safety.
Always lubricate the cutting blade with protective
spray before storage.
Keep all nuts, bolts and screws tight to be sure
that the machine is in safe working condition.
19