Technibel Climatisation MPW Notice D'installation page 12

F
MARKING
This product marked
GB - Low voltage no. 2006/95/CE,
- Electromagnetic Compatibility no. 89/336 EEC, modifi ed 92/31 and 93/68 EEC.
I
E
D
CONTENTS
1 - GENERAL
1.1 - FOREWORD
• The equipment must be installed, started-up and maintained
by authorised and qualifi ed personnel, in accordance with local
rules and professional standards.
1.2 - GENERAL SUPPLY CONDITIONS
• Generally speaking, the material is transported at the
consignee's risk.
• The consignee must immediately provide the carrier with
written reserves if he fi nds any damage caused during
transport.
1.3 - VOLTAGE
• Before any operation, check that the voltage and the frequency
indicated on the device corresponds with that of the mains.
2 - PRESENTATION
2.1 - DESCRIPTION
1 - Air inlet (suction).
2 - Air outlet (blowing).
3 - Vertical defl ection louvre.
4 - Horizontal defl ection louvre.
5 - Air fi lters.
• The BE is equipped with a 500 W electrical heating element and two safety thermostats (one automatic reset and one manual
reset).
2
conforms to the essential requirements of the European Directives:
1 - General ........................................................................ 2
2 - Presentation ................................................................. 2
3 - Installation of the unit ................................................... 3
4 - Connections ................................................................. 4
5 - Accessories ................................................................. 9
6 - Starting ...................................................................... 10
7 - Maintenance .............................................................. 10
8 - Wiring diagrams ..........................................................11
1
5
1.4 - PRECAUTIONS
1.4.1 - HYDRAULIC CIRCUIT
- Minimum water inlet temperature : 4°C.
- Maximum water inlet temperature : 60°C.
- Maximum operating pressure
1.4.2 - AMBIENT AIR
- Minimum air recirculation temperature : 5°C.
- Maximum air recirculation temperature : 32°C.
Important: During installation shut-down, in case of ambient
temperature near 0°C, there is a risk that the hoses may freeze.
Envisage draining the hydraulic circuit.
1.5 - USE OF EQUIPMENT
• This equipment is intented for the air-conditioning of premises
and to provide comfort for the personnel.
1.6 - MODELS
• "2-pipe" for all sizes.
• "2-pipe + electric heating" (with electric heating element) for
MPW 1 BE.
Materials:
2 4 3
: 16 bar.
• Plastic body.
• Copper piping.
• Copper/aluminum exchanger.