LaserLiner AutoCross-Laser ACL 4P RX Mode D'emploi page 11

A
B
D
G
Inserting the batteries ACL 4P RX and Laserreceiver RX 50:
Open the battery compartment (10, I) and insert the batteries in accordance
with the installation symbols, ensuring the correct polarity. Close the cover.
Aligning the ACL 4P RX
For approximate adjustment of the lasers, the top part of the ACL 4P RX can
be turned on the base. Precise positioning can then be done with the
precision adjustment knob (3). The adjustable feet (6) allow the device to be
positioned on sloping surfaces.
Switching on the ACL 4P RX:
Turn the ON/OFF switch (2) to the right, thereby releasing the transport
securing device. The lasers can now be individually activated via buttons
14, 15, 16. To obtain maximum visibility of the laser line, the hand receiver
mode must be switched off (button 13). In this case, it is not possible to work
with the laser receiver.
Note:
If the device is too far off the horizontal (more than 3°), the lasers will blink.
Align the device using the adjustable feet (6) or place on a more level
surface. The round vial (8) is provided as an aid to alignment.
AutoCross-Laser ACL 4P RX
C
E
F
H
I
ENGLISH
A Power indicator
B Switch accuracy
short range / long range
C LED for accuracy
green / red
D ON / OFF switch
E Sound ON / OFF
F Receiver field for laser beam
G LED's for Laserindication (front,
side, backside)
H Universal mount
I Battery compartment (backside)
11