Technical Data; Rating Plate - AEG HC451501EB Notice D'utilisation

18 www.aeg.com
The worktop cutout
Distance
from the
wall
Depth
Width
Example:
580 mm
Assembly
1. Calculate correct cutout dimensions.
2. Prepare cutout in the worktop.
3. One by one place the hobs on a soft
surface (for example on a blanket)
with the bottom side up.
4. Attach the supplied seal stripe to the
lower edge of the hob along the
outer edge of the glass ceramic.
5. Loosely screw the fixing plates into
the correct holes in the protective
casing.
6. Insert first hob into the worktop
cutout. Than insert the connection
bar into the worktop cutout. Push it
half of its width under the hob.
7. Loosely screw in the fixing plates
from below to the worktop and to
the connection bar.

9. TECHNICAL DATA

9.1 Rating plate

Model HC451501EB
Typ 56 WOK 03 AU
Induction 3.2 kW
minimum 50 mm
490 mm
sum of all widths of hobs that
you install minus 20 mm
+ - =
360 mm 20 mm 920 mm
8. Insert next hob into the worktop
cutout. Make sure that the front
edges of the hobs are on the same
level.
9. Tighten the fixing plates / retaining
grip screws.
10. Use silicone to seal the gaps
between the hobs and between the
hobs and the worktop.
11. Put some soapy water on the
silicone.
12. Press the rubber shape with some
strength against the glass ceramic
and move it slowly along the space.
13. Do not touch the silicone until it
becomes hard, it can last about a
day.
14. Carefully remove the silicone that
came out with a shaving blade.
15. Clean the glass surface.
PNC 949 595 441 01
220 - 240 V 50 - 60 Hz
Made in Germany