Jabra GN1000 Guide D'utilisation page 2

English - GN 1000 Remote Handset Lifter user guide
Thank you for choosing the GN 1000 Remote Handset Lifter (RHL) by GN Netcom,
which will provide you with the full benefi ts of GN Netcom cordless products. The
GN 1000 RHL is designed exclusively for use with GN Netcom cordless products.
This user guide will give you information and instructions on assembling, using and
maintaining your GN 1000 RHL and contains the following sections:
• About the GN 1000 RHL
• Assembling and assembly verifi cation
• Features and customisation
• Answering and making telephone calls
• Frequently asked questions
• Operational and safety information
A Connector cord
B On-line indicator
C Lifter Arm height control
D Lifter Arm (extendable; 2 positions)
E Housing
F Platform
GN 1000 RHL Accessories
M External Ring sensor
N Hook and Loop fasteners
O Adapter kit (see instructions in adapter kit bag)
2
GN1000_contents.indd 2-3
G Ring Sensor
H Adhesive pads
I External socket (back)
J Ring Sensitivity control (back)
K Ring Sensor on/off button
L AUX plug
About the GN 1000 RHL
When affi xed to your telephone, the GN 1000 RHL mechanically lifts/lowers your tele-
phone's handset from/to its cradle and remotely communicates with your headset. This
allows you to answer and terminate telephone calls, even while away from your desk.
Assembling and assembly verifi cation
Assembling the product involves locating and preparing the mount-
ing area as well as affi xing the platform. To assemble the product:
1. Take the product from the packaging and remove the quick set up
sleeve from the platform.
2. Locate the handset area of your telephone, as this is where the
product's platform will be affi xed. In general, you will affi x the
platform on the telephone, as close as possible to the handset's
receiver.
3. Line up the top edge of the platform as illustrated.
4. Remove the protective fi lm from the adhesive pad on the bottom
of the platform.
Note: The adhesive pad affi xes fi rmly to any surface. Ensure you
have determined the correct location before affi xing the adhesive
pad.
5. Affi x the platform fi rmly to the telephone with the adhesive pads,
as close as possible to the handset's speaker.
Note: If you are unable to affi x the platform with the adhesive
pads, use the hook and loop fasteners.
3
11-03-2003, 14:15:09