Brightness / Contrast; Buzzer; Information Menu - WLD-TEC Fuego SCS Mode D'emploi

5.4 Brightness / Contrast

This function allows the brightness and the contrast
of the display to be adjusted. To set the brightness /
contrast, select the symbol in the settings menu and
confirm with a short push on the function knob (1).
In the 1st step the brightness (values: 1 - 30,
factory default setting: 30) can be changed by
turning the function knob (1). Memorize the value
with a short push on the function knob (1). Next
set the contrast (values 1 - 25, factory default
setting: 15) and likewise memorize with a short
press on the function knob (1).

5.5 Buzzer

This function allows to switch on and off the built-
in buzzer. To set the buzzer, select the symbol in
the settings menu and confirm with a short push
on the function knob (1). By turning the function
knob (1), switch the buzzer on or off (factory
default setting: on).
To memorize and exit the
submenu, briefly push the
function knob (1).

5.6 Information menu

In the information menu a variety of system parameter settings can be accessed. In
order to access, select the information menu symbol in the settings menu and confirm
with a short push on the function knob (1). In order to access the individual information
sections, in each case briefly push the function knob (1).
Number of ignitions since switching on
Total number of ignitions
Foot pedal input internal value
Burner head
control value
Fig. 5.6/1
56
Fig. 5.5/2
Firmware version
Brightness / Contrast
Fig. 5.4/1
Fig. 5.4/2
Buzzer
Fig. 5.5/1
Buzzer
Main voltage
[Fuego pro]
Battery voltage
Contact details
Brightness
Contrast
on
Value voltage
Device interior
temperatur
off