Flame Regulation; Switching Off The Unit - WLD-TEC Fuego SCS Mode D'emploi

parameter or alternatively the time which is to be set. The parameter or time can now
be varied by turning the function knob.
Structure of menu
1
9
Fig. 2.3/2
Main menu level:
1 - Application program Button Start-Stop
2 - Application program Sensor Auto-Off
3 - Application program Sensor Start-Stop
4 - Application program Pedal Standard
5 - Application program Pedal Start-Stop
6 - Operation mode: Temperature regulation program
7 - Reminder function menu
8 - Settings menu

2.4 Flame regulation

The flame can be varied in size and intensity by turning the gas / air knob (2).
Regulating the size of the flame is done by turning the gas / air adjustment. Regulating
the air intake for the flame intensity is carried out by pulling outwards and at the
same time rotating the gas / air adjustment.
When using for the first time or changing the gas type, turn the gas / air adjust-
!
ment knob two revolutions to the left. Then pull the gas / air adjustment outwards
and simultaneously turn it one revolution to the left to open the air intake.

2.5 Switching off the unit

The unit can be turned off by a long push (2 seconds +) on the function knob. During
switching off, the device follows a "Zero pressure" procedure to lower the pressure in
the supply hose. After a long push of more than 2 seconds, the device thus starts an
animated display to remind you to turn off the gas supply and reduce the gas pressure
from the supply hose.
To do this, press the function knob (1) briefly during the switch off routine once again to
start the ignition of the unit and to burn off the residual gas in the hose.
46
2 3
10 11
Main menu level
4 5
Settings menu level
12
6 7
13 14
Settings menu level:
9 - Burner Head Control (BHC)
10 - IR-Sensor settings
11 - Stand-by
12 - Brightness / Contrast
13 - Buzzer on / off
14 - Basic unit data
15 - Factory default settings
8
15