Mains Power Supply; Foot Pedal Connection; Fuego Pro] Rechargeable Nimh Batteries - Transportation Lock - WLD-TEC Fuego SCS Mode D'emploi

connections with test solution or soapy water and look for bubbles. If bubbles
form or if one bubble becomes larger, there is a leak. Immediately turn off the
gas supply.
Check all gas supply connections or gas joints (e.g.: at the gas cartridge / gas
bottle, at the laboratory gas burner or at an additional gas leak protection).
In the event of leaks, tighten up the gas joints with a wrench and test again for
gas proofness. Never use an open flame to look for leaks.

1.3 Mains power supply

Plug the power cable into the socket (9) on the back of the unit or into the socket of
the optional foot pedal. The mains power supply unit included is designed for a voltage
from 100 - 240 V, 50/60 Hz. The mains power supply unit may only be connected if
these values comply with the intended electricity supply. Before using it, push the
corresponding socket adapter onto the mains power supply plug.

1.4 Foot pedal connection

Insert the connection cable of the foot pedal into the socket (8) at the back of the unit.
The foot pedal is an optional accessory.
If no pedal is connected, the symbol for
i
connecting appears in the "Pedal-
application programs". On the display a
foot pedal and the automatic inoculation
loop carrousel Autoloop Pro are displayed.
Available foot pedal:
Foot pedal made of stainless steel:
Foot pedal Mini made of plastic:
Wireless radio frequency foot pedal (EU-countries only):
Automatic carrousel for flame sterilising:
Autoloop Pro
Additional information at www.wld-tec.com.

1.5 [Fuego pro] Rechargeable NiMH batteries - transportation lock

The NiMH rechargeable batteries included in the delivery are already charged and
inserted in the battery compartment (20) for operation independently of the mains
power supply. To operate the device with the batteries, just remove the transportation
lock (20a) in the direction of the arrow.
The rechargeable batteries will be discharged to
i
a certain extent after long storage periods. Hence,
under certain circumstances, the full number of
operating hours may not be achieved during inital
use. Please recharge the batteries if necessary
after long storage periods (see paragraph 2.6 & 8).
44
Connection symbol
Fig. 1.4/1
Art.-No.: 6.000.402
Art.-No.: 6.000.403
Art.-No.: 8.000.404-RF
Art.-No.: 8.000.400
20
20a
Fig. 1.5/1