Siemens euroset 2020 Mode D'emploi page 9

Table des Matières

Les langues disponibles

28.01.2000

2020-IM1-eng.fm

euroset 2020, A31008-E2020-B100-1-3S19

Operation at private PABXs

E E E E n n n n t t t t e e e e r r r r i i i i n n n n g g g g / / / / d d d d e e e e l l l l e e e e t t t t i i i i n n n n g g g g e e e e x x x x c c c c h h h h an an an ang g g g e e e e c c c c o o o o d d d d e e e e s s s s

If you are using your telephone on a private PABX, you may need to store

one or more exchange codes. A dialling pause of 3 seconds is automatical-

ly set when the exchange code is programmed.

Lift the handset, then start the function.

If no exchange code has been programmed, the dis-

play shows .

If one or more exchange codes have been stored,

these are displayed side-by-side; the code currently

available for editing flashes.

Press

codes as necessary in order to edit them as follows:

(a) To d d d d e e e e l l l l e e e e t t t t e e e e an exchange code:

Press the set key and replace the handset.

(b) To e e e e n n n n t t t t e e e e r r r r an exchange code:

Enter a one to three-digit exchange code.

I I I I f f f f y y y y ou ou ou ou w w w w an an an ant t t t t t t t o e

Press the redial key and enter the next exchange

code.

Press the set key, then replace the handset.

S S S S w w w w i i i i t t t t c c c c h h h h i i i i n n n n g g g g t t t t h h h h e e e e d d d d i i i i a a a a lli lli lli llin n n n g g g g m m m m o o o o d d d d e e e e

Lift the handset, then start the function.

1 1 1 1 = Tone dialling.

2 2 2 2 = Pulse dialling without flash function.

Press the set key, then replace the handset.

S S S S w w w w i i i i t t t t c c c c h h h h i i i i n n n n g g g g t t t t h h h h e e e e d d d d i i i i a a a a lli lli lli llin n n n g g g g m m m m o o o o d d d d e e e e w w w w h h h h i i i i l l l l e e e e c c c c onn

If your telephone is set to pulse dialling and you want to use functions that

require tone dialling (e.g. remote replay on an answering machine), you

can switch the dialling mode while connected.

While connected: press the asterisk key.

The dialling mode is switched.

Enter the digits for remote control/data transfer.

You can revert to the original dialling mode by replacing the handset.

to switch between the displayed exchange

o en n n n t t t t e e e e r r r r ano

o e

anot t t t h h h h er er er er e e e e x x x x c c c c h h h h an an an ang g g g e e e e c c c c o o o o d d d d e e e e : : : :

ano