Sangean ATS-909X Mode D'emploi page 23

To Manually Set Memory on SW Band:
Tune to station you would like to program into memory. Press
GB
Memo button, MEMO will flash in the LCD display. Select page
desired by using the PAGE button and Rotary Tuning Knob.
Display will flash and next available position on display will flash
if an available position is available. Press Enter Selection button
to assign frequency to flashing available position. If memory is full
no suggested position will flash and LCD will display MEMO FULL
when any button is depressed. If selected button is held for more
than 2 seconds, even with MEMO FULL flashing. Newly selected
station will replace existing station.
You may change or initiate any page name at any time by first
selecting the page and then pressing the EDIT button and using
the Rotary Tuning Knob to place an alphanumeric character in the
name space in the LCD Display. Once a character is selected you
may move to the next position to place another character by using
the Tuning Up/Down button. When name is completely entered
press Enter Selection button.
Note:
You may change and edit your SW band's pages names, but there
is no FM/MW/LW page name. You may change and edit your FM/
MW/LW bands' preset names, but there is no any SW preset name.
Note:
Every memory preset memory can be stored including its
frequency, mode (AM/LSB/USB), and fine tuning frequency.
22