ADEO Services YT4334-01 Notice De Montage Et D'entretien page 51

Suspected malfunctions are often due to causes that the users can fix themselves. Therefore check the
product using this section. In most cases the problem can be solved quickly.
Problem
Product does not start
Product does not reach full power Extension cord not suitable for
Unsatisfactory cutting
performance
Excessive vibration/noise
The product comes in a package that protects it against damage during shipping. Keep the
package until you are sure that all parts have been delivered and the product is function
properly. Recycle the package afterwards.
CAUTION! This product shall not be discarded with household waste but that it shall be
returned to a collection system which conforms to the European WEEE Directive. Contact your
local authorities or stockist for advice on recycling. It will then be recycled or dismantled in order
to reduce the impact on the environment. Electric and electronic equipment can be hazardous
for the environment and for human health since they contain hazardous substances.
TROUBLE SHOOTING
Possible cause
Not connected to power supply
Power cord or plug is defective
Other electrical defect to the
product
operation with this product
Power source (e.g. generator) has
too low voltage
Air vents are blocked
Saw chain not tensioned properly Tension properly
Blunt saw chain
Saw chain is dull/damaged
Bolts/nuts are loosen
51
Solution
Connect to power supply
Check by a specialist electrician
Check by a specialist electrician
Use a proper extension cord
Connect to another power source
Clean the air vents
Sharpen or replace the saw chain
Replace with a new one
Tighten bolts/nuts
EN