Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
malfunction. Have the product
EN
checked by a qualified specialist
and repaired, if necessary, before
you put it into operation again.
Maintenance
If the supply cable is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
If the carbon brushes need to be
replaced, have this done by a qualified
repair person (always replace the two
brushes at the same time).
Residual risks
Even if you are operating this product
in accordance with the provisions,
residual risks will always still remain.
The following dangers can arise in
connection with the structure and
design of this product:
1. Health defects resulting from
vibration emission if the product
is being used over longer period of
time or not adequately managed
and properly maintained.
2. Injuries and damage to property
to due to broken accessories or
hidden objects that are suddenly
dashed.
3. Injuries and damage to property to
due to thrown and fallen objects.
4. Prolonged use of this product
SAFETY INSTRUCTIONS
48
expose the operator to vibrations
and may produce 'whitefinger'
disease. In order to reduce the
risk, please wear gloves and keep
your hands warm. If any of the
'whitefinger' symptoms appear,
seek medical advice immediately.
'Whitefinger' symptoms include:
numbness, loss of feeling, tingling,
pricking, pain, loss of strength,
changes in skin colour or condition.
These symptoms normally appear
in the fingers, hands or wrists. The
risk increases at low temperatures.
Attention!
conditions of the electical
MAINS, shortly voltage drops can
appear when starting the EQUIPMENT.
This can influence other equipment
(eg. Blinking of a lamp). If the MAINS-
IMPEDANCE Zmax<0.390Ω, such
disturbances are not expected. (In
case of need, you may contact contact
your local supply authority for fur ther
information).
Through
poor
Publicité
Table des Matières
