1
To open the pressing jaw, push the ends of the jaw levers
together. Position the open pressing jaw on the fitting bead
of the pressfitting (refer to figure A, cover page at the back).
2
Make sure that the pressing jaw is positioned correctly on
the fitting bead of the pressfitting (refer to figure B, cover
page at the back).
3
Release both jaw levers.
4
Press the pressfitting; see operating instructions for the
pressing tool.
5
After the pressing operation has been completed, make
sure that the pressing jaw is completely closed (refer to
figure C, cover page at the back).
6
Release the pressing jaw from the pressfitting (refer to
figure D, cover page at the back).
B262-006 © 01-2014
964.876.00.0 (05)
EN
21