Geberit Mapress Mode D'emploi page 19

Operation
Inserting the pressing jaw in the pressing tool
The procedure for inserting the pressing jaw depends on
the type of pressing tool and is therefore described in the
operating instructions of the pressing tool.
Placing the pressing jaw on the pressfitting
WARNING
Risk of injury caused by flying fragments if used
incorrectly or if worn or damaged pressing jaws are used
Only use the pressing jaw if it is in perfect working order
(see the basic safety notes)
Make sure that the diameter of the pressfitting matches
the diameter of the pressing jaw
Do not tilt the pressing jaw on the pressfitting
Clean away any dirt, chips or the like between the
pressing jaw and the pressfitting
If the pressing jaw has been used incorrectly, or in a way
that does not comply with its intended use, do not
continue to use it and have it inspected by an authorised
repair shop
Wear suitable protective equipment (protective goggles
etc.)
B262-006 © 01-2014
964.876.00.0 (05)
EN
19