Placing Of The Insert - FAR KJ 45/S Traduction Des Instructions Originales

KJ 45/S KJ 45/S
f3
M12
1 ÷ 4 15
Tie rod max. stroke Revolutions (M)
~ 8 mm
PLACING OF THE INSERT (fig. f4-f5-f6)
Check that the threaded tie rod (A) and head (B) couple
assembled on the riveting tool is suitable to the size of the
insert to be used.
Adjust the stroke as indicated (fig. f2-f3).
Introduce the insert on the tie rod (A) and push slightly on it
as indicated in figure f4, so as to make it clamp automatically
on the threaded tie rod. Make sure that the insert head touches
the head (B) checking that the tie rod (A) comes out of 2mm
from the insert.
In case of further adjustments of the tie rod (A) follow the
instructions of page 18.
It is now possible to place the insert pushing the button (D)
(fig.f5) until the insert is completely pulled, and push the
button (P) to release the tie rod (fig.f7).
For a correct placing and right working of the machine, the
inserts to be used should be properly cleaned.
Note: According to the desired clamping, carry out other
adjustments of the riveting tool stroke, rotating the knob
(M) (fig. f2-f3-f6), if necessary.
Insuffi cient deformation = the insert could rotate inside the
housing compromising its use and resistance.
Excessive deformation = possible damages of the insert
and tie rod (A) with eventual breaks of both components.
f4
A B
Revisione - 04
10
11
12
13
14
Tie rod stroke
15 ~ 0.4 mm
GB
8
7
9
6
Revolutions (M)
1
M
Date 01-2012
5
4
3
2
1
0
Tie rod min. stroke
~ 2 mm
D
Revolutions (M)
0
f5
f6
15