Tool Identification; General Notes And Use; Main Components; Technical Data - FAR KJ 45/S Traduction Des Instructions Originales

KJ 45/S KJ 45/S

TOOL IDENTIFICATION

The riveting tool KJ 45/S is identified from a marking
that shows company name and address of manufacturer,
designation of the tool, CE mark and year of manufacturing.
If any service is requested, please make reference to the data
shown on the marking.
Company name and
address
Year of manufacturing

GENERAL NOTES AND USE

The tool can be employed only for threaded inserts M4÷M12.
The KJ 45/S/S hydropneumatic system assures more power
than the pneumatic system used for other models. That means
a reduction in the problems due to the wear and tear of the
components, therefore, there will be an increase in reliability.
The technical solutions adopted reduce the dimensions and
the weight of the tool, which is very handy for these reasons.
The possibilities of leakage from the oil-dynamic system, are
eliminated by some sealed gaskets, which solve this problem.
Revisione - 04
Designation of the tool
GB

MAIN COMPONENTS

A) .........................................................................Threaded tie rod
B) .......................................................................................... Head
C) .............................................................Ring-nut clamping head
D) ...................................................................Control push-button
E) ....................................................... Compressed air connection
F) ............................................................... Pressure control valve
G) ......................................................................Protection bottom
H) ....................................................................... Pneumatic motor
I) ................................................................................Oil tank plug
L) ...................................................................Balancer connection
M) ...............................................................Stroke-adjusting knob
N) ......................................................................... Stroke indicator
O) .................................................................... Tube carrying head
P) .....................................................................Unscrewing button
Q) ......................................................................
with M10 tie rod
*

TECHNICAL DATA

• Working pressure ....................................................... 6 - 7 BAR
• Min. int. diam. of the compressed air
feeding hose ..................................................................... 8 mm
• Max free air consumption per cycle ................................
• Maximum force .........................................
• Weight (with equipment for M10)................................2,860 Kg
• Working temperature ................................................... -5°/+50°
• Root mean square in total acceleration
frequency (Ac) to which
the arms are subjected ............................................. < 2.5
** nl = litres at 20°, pressure of 1 atmosphere
• A-weighted emission sound pressure level ...................
• Peak C-weighted instantaneous sound pressure .......
• A-weighted emission sound pressure ...........................
Date 01-2012
Air-entry valve
9 Nl**
6,5 BAR - 27440 N
m/s 2
74 dBA
<130 dBC
86 dBA
13