Honeywell IFM N95000 Mode D'emploi page 7

 Permissible operating temperature of the application (referred to the
maximum power which can be supplied):
N95000 and NF503A
Ta: -25...+55°C (T6)
Ta: -25...+60°C (T5)
Ta: -25...+70°C (T4)
 Maximum effective internal inductance (Li) and capacitance (Ci):
Li = 100 µH, Ci = 90 nF
The values apply to potted connection wires which are 0.5 m long.
.
3 Installation remarks / Installation
 Adhere to the relevant national regulations and provisions.
 Avoid electrostatic charging on plastic units and cables.
 Protect unit and cable against destruction.
 The units must not be installed in the partition between different zones.
 In principle, the type test only takes atmospheric conditions into account.
For conditions outside these ranges use must be assessed and approved
by the user.
 The equalisation of potential of metal housing parts must be ensured by
appropriate mounting.
4 Connection configurations
5 Maintenance / Repair
The unit must not be modified nor can it be repaired. In case of a fault
please contact the manufacturer. If needed, you can obtain data sheet or
type test certificate from the manufacturer.
73024995a © Elster GmbH | All rights reserved. Subject to modification
Honeywell
7