SORHEA BIRIS II 50 Notice D'installation page 27

SORHEA
Description of the cell viewfinder
1. Place the eye in front of the cell along an
oblique line of sight at a distance of about 5
cm as shown in the accompanying figure.
2. Aiming consists in viewing the image of the
opposite module in the internal mirror (see
figure above) using the opening on the side
of the cell.
3. Aiming is performed by rotating the sight
horizontally by directly manipulating the cell
fork + or - 90°, and by vertically rotating the
sight by manipulating the knobs + or - 10°.
Optimization of alignment
Steps
1) Switch 5 and 6 to OFF
Switch 5 and 6 :
select operationg mode
ON
MODE
5 6
ON
OFF
2) Switch 1 and 2 to ON
Switch 1 and 2 :
alignment mode
ON
ALIGN. CHANNEL
1 2 3 4
ON
OFF
Alignment
BIRIS II 50
TX column RX column
-
ON
OFF
1 2 1 2
ALIGN.
ALIGN.
RX
- Buzzer ON
The incoming signal level is proportional to the sound frequency
Constant Constant
green LED red LED
Heating switch inactive and forced heating off
Sight
Cell support
BIRIS II 100
TX column
ON
-
OFF
5 6
MODE
ON ON
OFF
OFF
1 2
ALIGN.
DELAY
-
Constant
green LED
- 26 -
BIRIS II 50/100/200
5 cm
Oblique sighting
/ 2in
Knobs
Sighting image
BIRIS II 200
RX column TX column
ON
OFF OFF
5 6
5 6
MODE
MODE
ON ON
OFF
OFF
1 2
1 2
ALIGN. ALIGN.
Buzzer ON Buzzer ON Buzzer ON
The incoming signal level is
proportional to the number of LED lit
(bargraph)
RX column
ON
ON
OFF
5 6
MODE
ON
OFF
1 2
ALIGN.