Spypoint I-6 Manuel D'utilisation page 4

6
POWER
The battery level is shown in the lower left corner of the LCD
screen. When a single line remains, the camera will continue to
take pictures but we strongly recommend changing the batteries
before they are empty. (See figure below)
AA BATTERIES
This camera requires the use of 6 AA batteries (1.5V). The
use of alkaline or lithium batteries is strongly recommended.
During the installation of AA batteries, place the switch inside
the battery case to "ALK" (i.e. alkaline). Insert the batteries
as indicated inside the battery case. Exact polarity must be
followed. We also recommend the use of new batteries to
ensure maximum performance of your camera.
LITHIUM BATTERY PACK
The camera can be powered by a rechargeable lithium battery
LIT-09/LIT-C-8 (sold separately, see section "OPTIONS").
This type of battery is less affected by cold temperatures and
lasts up to 3 times longer than an alkaline battery. During
the installation of lithium battery, place the switch inside the
battery case to "LIT-09".
EXTERNAL (12V)
The camera can be powered from an external 12-volt DC input
such as a 12-volt battery (KIT-12V/BATT-12V, sold separately)
or a 12-volt adapter (AD-12V, sold separately). When using a
12-volt connection, we recommend removing the AA batteries
to prevent surcharges. During the installation of a 12-volt
connection, place the switch inside the battery case to "ALK"
(i.e. alkaline). If combined with a lithium battery pack, slide the
switch to "LIT-09". To find the accessories available for the
12-volts, see section "OPTIONS".
MEMORY STORAGE
Using a memory card (sold separately, see section "OPTIONS") is
required to operate the camera. When the camera is "ON" and no
memory card is used, the LCD panel displays "CArd" meaning to
The camera is compatible with SD/SDHC memory
insert one.
card, up to 32 GB capacity. Before inserting or removing a
memory card, the camera must be turned off. Failing to do
so may cause loss of pictures or damage the pictures already
saved on the memory card. When the SD card is full, the LCD
panel indicates "FUL". The following data shows an approximate
quantity of photos which can be recorded by the camera depending
on the memory card capacity.
RESOLUTION 2.0 GB
4 MP 1900
6 MP 1600
VIDEO RESOLUTION
320 x 240 2h
640 x 480 65 min
"BUSY" LED
The "BUSY" light, located next to the screen, lights up when
the camera is recording.
4.0 GB 8.0 GB 32 GB
3800 7600 30400
3200 6300 25300
4h 8h 32h
2h10 4h10 16h40
7