▶ Do not under any circumstances modify or tamper with batteries!
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C
(176 °F).
▶ Never use or charge a battery that has suffered an impact or been damaged in any other way. Check
your batteries regularly for signs of damage.
▶ Never use recycled or repaired batteries.
▶ Never use the battery or a battery-operated power tool as a striking tool.
▶ Never expose batteries to the direct rays of the sun, elevated temperature, sparking, or open flame. This
can lead to explosions.
▶ Do not touch the battery poles with your fingers, tools, jewelry, or other electrically conductive objects.
This can damage the battery and also cause material damage and personal injury.
▶ Keep batteries away from rain, moisture and liquids. Penetrating moisture can cause short circuits,
electric shock, burns, fire and explosions.
▶ Use only chargers and power tools approved for the specific battery type. Read and follow the relevant
operating instructions.
▶ Do not use or store the battery in explosive environments.
▶ If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3
Description
3.1
Product overview
3.1.1
Equipment
The fastener guide and the support leg are product-dependent. The support legs and fastener guides with
which the product is equipped are listed in the table below.
Further information can be found in the case lid, in your Hilti Store or at: www.hilti.group
Product
Fastener guide
6
English
1
BX 3-22
X-FG B3 IF 02
Nosepiece
@
Fastener guide
;
Fastener guide locking catch
=
Single-fastener head (BX 3-ME-22)
%
Air vents
&
Eye for tool tether
(
Belt hook
)
Safety trigger
+
Grip
§
Belt hook/scaffold hook
/
Battery release button
:
Battery status indicator
∙
Liion battery
$
Installation opening for accessories
£
Nail pusher
|
Nail pusher release mechanism
¡
Support leg
Q
Magazine
W
Status indicator, fastening tool
E
Work-area light
R
BX 3-L-22
X-FG B3 IF 02
2268214
*2268214*
BX 3-ME-22
X-FG B3 ME