Operating Elements And Connections; Applications; Power Supply - Monacor JTS PT-850B/2 Mode D'emploi

All operating elements and connections described
can be found on the fold-out page 3.

1 Operating Elements and Connections

1 Transmitting antenna
2 Power switch
3 Microphone connection (4-pole mini XLR jack)
4 LED status indication: shows
– green as a power indication
– red when the batteries are almost exhausted
5 Rotary switch CH for adjusting the transmission
channel with the adjusting key supplied
6 Gain control; for matching the input sensitivity, turn
the control with the adjusting key supplied
7 Battery compartment for two 1.5 V batteries of
size AA (R6)
8 Battery compartment cover
2 Important Notes
The unit corresponds to all relevant directives of the
EU and is therefore marked with
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity, and heat (admissible ambient temperature
range 0 – 40 °C).
G
For cleaning only use a dry, soft cloth; never use
chemicals or water.
G
No guarantee claims for the unit and no liability for
any resulting personal damage or material damage
will be accepted if the unit is used for other purposes
than originally intended, if it is not correctly operated
or not repaired in an expert way.
If the unit is to be put out of operation defini-
tively, take it to a local recycling plant for a
disposal which is not harmful to the environ-
ment.
Dead batteries or defective rechargeable batteries
do not belong in the household rubbish; always take
them to a special waste disposal (e. g. collecting con-
tainer at your retailer).

3 Applications

Together with the receiver US-8001D/ 2 (1 receiving
unit) or US-8002D/ 2 (2 receiving units) from JTS, this
UHF PLL pocket transmitter makes up a wireless
audio transmission system. The transmission channel
6
can be selected as desired among 16 channels in the
UHF frequency range of 740 to 764 MHz.
bag for fastening the transmitter to your clothes and
with the Lavalier microphone CM-501. Instead of
the microphone, it is also possible to use e. g. the
headband microphones CM-204..., CM-801F and
CM-804IF or the instrument microphones CX-508W
and CX-516W from JTS.
3.1 Conformity and approval of the transmitter
Herewith, MONACOR INTERNATIONAL declare that
the unit PT-850B/ 2 is in accordance with the basic
requirements and the other relevant regulations of the
directive 1999 / 5 / EC. The declaration of conformity
can be found in the Internet via the JTS home page
(www.jts-germany.de).
This unit may be operated in the following countries:
DE
In the Federal Republic of Germany, the pocket trans-
mitter requires a frequency assignment (for which a
fee is charged).
In other countries, it is necessary to apply for a corre-
sponding approval. Prior to operating the pocket trans-
.
mitter outside Germany, please contact the MONA-
COR subsidiary or the corresponding authorities of the
respective country. Links to the national authorities
can be found via the following Internet address:
www.cept.org
→ ECC
→ Topics
→ Short Range Devices (SRD) and other R&T TE
→ EFIS and National Frequency Tables

4 Power Supply

G
G
1) Open the Velcro fastener and take the transmitter
2) Remove the cover (8) of the battery compartment.
3) Insert two 1.5 V batteries of size AA (R6) with the
4) Replace the cover.
The transmitter is supplied with an artificial leather
sub-classes
Only insert batteries of the same type and always
replace all batteries.
If the unit is not used for a longer period (e. g. more
than a week), remove the batteries. Thus, the unit
will not be damaged in case of battery leakage.
out of the belt bag.
This will allow access to the battery compartment
(7).
positive and negative connections as indicated in
the compartment.