Inserting The Print Paper - Sony PVP-MSH Mode D'emploi

Inserting the print paper

Be sure to use the specified print paper.
The descriptions in this manual are for the DCR-TRV30.
For details on camcorder operation, refer to the operating instructions of
your camcorder.
1
Perform steps1 and 2 on page 12, and prepare the power
supply.
2
Make sure that the PAPER lamp is flashing slowly, and then
insert a sheet of print paper into the paper feeder straight
making sure that the print surface is facing up.
Insert the print paper until less than 3 cm of print paper is protruding
from this unit.
Press the print paper into the paper feeder for about two seconds after
the beep.
The print paper starts to be automatically drawn in.
• When the CARTRIDGE lamp is flashing slowly, check the print
cartridge.
• If print paper is not inserted, the PAPER lamp flashes slowly. The
PAPER lamp flashes fast when an error occurs.
PNote
After you have inserted the print paper, do not close the printer cover until
printing ends. Doing so may cause this unit to malfunction.
Less than
3 cm
13-US