Marmitek GSM Guard 300 Mode D'emploi page 9

3. Switching the relay
If you have connected a lamp to the relay (according to the connection diagram, see step 6),
in the Setup menu you can turn the relay on or off.
• Press 'Setup' and select 3 (3: RELAY).
• The display reads: 'Relay OFF, (1) ON, (2) OFF'.
• Press the numerical keys 1 or 2 to switch the relay on or off.
• Press 'Enter'.
• Press 'Setup' to return to the Setup menu. The relay flashes to indicate that the relay is on.
3. Using the Marmitek GSM Guard 300
TIP: Write down the telephone number of the SIM card in the Marmitek GSM Guard 300, or
better, save it in your (mobile) phone's memory.
Before you leave
Step 1.
Select what type of message you want to receive in case of an alarm. The GSM Guard 300
uses shortcuts to set the module to 'SMS on' and/or 'Buzzer on'. When you leave the house,
you want to trigger the siren and receive text messages in case of an alarm. This can be set as
follows:
Press the numerical keys 6, 7 or 8 once to activate the corresponding function.
Press the button again to deactivate the function.
6: SMS on/off (text messages on/off)
7: Buzzer on/off (siren on/off)
8: SMS and Buzzer on/off (text messages and siren on/off)
When you deactivate text messages or the siren, the red LEDs for SMS OFF and
Buzzer OFF will flash. This does not have any adverse effects.
Figure 7
Step 2.
After selecting the setting for text messages or the siren, press Reset. You now have 90 sec-
onds (delay) to leave your house, caravan or car.
TIP: If the relay is still on, it is now turned off. If you want the relay to remain on, you can
press 0 in stead of Reset. The sensors will now also be turned off for 90 seconds, but the
relay will stay on.
TIP: Before pressing Reset, the display needs to indicate that all sensor contacts are closed by
displaying the text Normal. If one of the contacts is open, the display will read Trouble and
the LED for Wireless Switch will flash.
GSM GUARD 300 9