Marmitek GSM Guard 300 Mode D'emploi page 4

2. Installation
The standard Marmitek GSM Guard 300 consists of a GSM Guard 300 module and two
door/window sensors. Connect the door/window sensors (using tape or a screw) to the
frame. The magnetic sensor can be placed on the window or door, at exactly the same height
as the sensor on the frame (the alignment has to be totally accurate for it to work!). Unlock
the SIM card with a mobile phone and place the card in the GSM Guard 300. Follow the
instructions for installation on the display to secure your home. You can use as many
door/window sensors as you want. These sensors are available separately.
As soon as the alarm goes off, the sensor contacts the GSM Guard 300, which sends a text
message to the phone number you entered. If you have connected a siren, this will also be
activated in case of an alarm. The Marmitek GSM Guard 300 has a built-in relay. This offers
you the opportunity to connect e.g. a lamp which will be turned on when the alarm is trig-
gered.
Attention: We advise you to read this entire user manual before starting the installation. The
GSM Guard 300 exits the Setup mode after about 20 seconds, which means that you lose
any settings you already entered. Make sure you know what all the buttons do first.
Step 1 Testing the SIM card and unlocking the PIN
• Unlock the PIN of the SIM card (of a provider of your choice) by placing it in a mobile
phone. Read the user manual of your mobile phone for information about unlocking
your SIM card.
• Use your mobile to check whether you can send and receive text messages (SMS) with
the SIM card.
• Use your mobile to check whether the range of the SIM card is sufficient at the place
where you want to place the GSM Guard 300 module (e.g. in a cupboard).
Attention: To be able to use the Marmitek GSM Guard 300, the SIM card needs to be
unlocked.
Step 2 Installing the SIM card
Figure 1
• Open up the back of the GSM Guard 300 module by loosening the two screws
and pushing the flap down.
• Open the SIM card holder by moving the yellow lip to the left. The black holder can be
removed from the GSM Guard 300 module. See figure 1.
• Place the SIM card with the chip-side up; this side will make contact with the Mobile
SMS Guard 300 module. There is an identical
notch in the SIM card holder, which means
the SIM card should fit perfectly. See figure 2.
• Place the SIM card holder with SIM card back
into the GSM Guard 300 module.
4
Figure 2
MARMITEK