Marmitek GSM Guard 300 Mode D'emploi page 11

Remotely control the system
Attention: Use exactly the right spelling (also use of capitals and hyphens), otherwise the
commands will not work.
You can communicate with the GSM Guard 300 by sending text messages. Use the following
messages:
Text message
ALARM-ON
ALARM-OFF
RELAY-ON
RELAY-OFF
RELAY-TIME X.X
CONTROL
CHECK
RESET
Type in the text message on your mobile phone and send it to the phone number of the SIM
card.
If you make a typing error, you will receive the following message: 'WRONG INSTRUCTION!'.
Check whether you have spelled the command correctly, with use of capitals and
(if necessary) hyphens.
TIP: Make templates for text commands you use more often and save these in your mobile
phone's memory.
GSM GUARD 300
Meaning
Command to activate the text and siren
Command to deactivate the text and siren functions
Command to activate the relay
Command to deactivate the relay
Command to set the ON time for the relay.
This can be set to a value between 0.1 minute and 99.9 minutes.
Example: RELAY-TIME 20.3 : the relay will remain on for
20.3 minutes after the command CONTROL is given.
Command to activate the relay for the duration set for RELAY-TIME.
Command to check the system status
Command to reset the alarm system. Attention: if you send this
command, you will not receive a text message. The system will
do a reset and deactivate the relay. The alarm system will
reactivate after 90 seconds.
11