Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
FR
DE
ES
IT
WARNING:
Before inspecting, cleaning, or servicing the
machine, shut off motor, wait for all moving
parts to stop, and disconnect plug from power
source. Failure to follow these instructions can
result in serious personal injury or property
damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, petrol,
petroleum based products, penetrating
oils, etc., come in contact with plastic parts.
Chemicals can damage, weaken or destroy
PROBLEM
Pressure washer does
not start when trigger is
depressed
Pump doesn't produce
pressure
PT
NL
SV
DA
NO
FI
English(original instructions)
TROUBLESHOOTING
POSSIBLE CAUSE
SOLUTION
Connect the power cord to a live 220-240V AC, 50 Hz AC
P o w e r
c o r d
n o t
socket.
connected to power
source
Turn switch on.
Switch is off
Reset house breaker. Make sure pressure washer is
connected to an individual branch circuit only. If using an
House circuit breaker
extension cord, make sure it is heavy enough to carry the
is tripped
current of the pressure washer.
Provide adequate water flow. If applicable, Check suction
hose filter is below the water level. Otherwise, turn water
I n a d e q u a t e w a t e r
supply off. Remove garden hose. Turn tap on to check water
supply
flow. If there is no water, fix water supply issue. If there is
water, check other troubleshooting solutions.
Lance leaks
Check connections and / or replace lance.
Nozzle is clogged
Clean nozzle.
Pump is faulty
Contact authorized service centre.
Air in line
Squeeze trigger on gun to remove air from line.
Water inlet filter is
clogged or dirty
Remove the water inlet filter, rinse with warm water, then
replace in unit.
HU CS RU
RO PL
SL
plastic which may result in serious personal
injury. Only the parts shown on the parts list
are intended to be repaired or replaced by the
customer. All other parts should be replaced at
an authorized service centre.
POWER SUPPLY CORD REPLACEMENT
If replacement of the power supply cord is necessary, this
must be done by an authorized service centre in order to
avoid a safety hazard.
STORING THE PRESSURE WASHER
Store in a dry, covered, frost-free area where the weather
can't damage it. Always empty water from gun, hose and
pump.
NOTE: The use of a pump protector is recommended to
prevent cold weather damage during storage over the
winter months.
13
HR ET
LT
LV
SK BG
Publicité
Table des Matières
