Display - Teac NR-7CD Mode D'emploi

When the unit is turned on
WELCOME
TEAC
NR-7CD
After messages like the above appear, the input source will be
shown on the display.
Input source information
The input source information screen will appear after turning the
unit on as well as after about 10 seconds pass without operation on
a setting screen.
Display example
Input source name
OPT1
PCM 44k
Input signal status
o Turning the VOLUME knob will change the volume, and the vol-
ume will appear to the right of the input signal status.
Input source name
This shows the name of the selected source.
The names on the display correspond to the selected connectors as
follows.
CD
CD player in this unit
NET
ETHERNET port, USB port
COAX
RCA COAXIAL digital audio input connector
OPT1
Optical digital audio input connector 1
OPT2
Optical digital audio input connector 2
LINE
Analog audio input connectors
o When using Bluetooth, the name of the connected device is
shown.
c
51
- .5
Volume
Input signal status
This shows the input source signal status.
UNLOCK!
The unit cannot synchronize with the input signal.
NOT AUDIO!
A signal with a format that cannot be played is being received.
NETWORK!
The input source is NET, but the unit is not connected to a
network.
READY
The input source is NET and it is connected, but no audio signal
is being received.
WAV 44k
DSD 2.8M
DSD 5.6M
FLAC96k, etc.
These are abbreviations of the input signal type and sampling
frequency.
SBC
AAC
aptX
LDAC
When the input source is Bluetooth, abbreviations of the codec
type and sampling frequency are shown.
Volume display
The volume setting shown will be enlarged when you turn this
unit's VOLUME knob.
Display example
Volume -

Display

60
.0dB
EN
17