Introduction & Features; Safety Instructions - Velleman VTSS110 Notice D'emploi

VTSS110 – MULTIFUNCTIONAL REPAIR STATION
1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying a Velleman product! The VTSS110 is used for soldering and desoldering all types of SMDs
(Surface-Mounted Devices). It features an anti-static design, a ceramic heating element, an RTD sensor and an
automatic cooling function. Please read the manual thoroughly before bringing this device into service. If the device was
damaged in transit, don't install or use it and contact your dealer.

2. Safety Instructions

CAUTION: Misuse may cause injury and physical damage. For your own safety, be sure to
comply with the following precautions.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• Make sure the unit is grounded. Always connect to a grounded mains plug.
• Tip temperature may reach as high as 480° when switched on. Therefore, do not use near flammable gases,
paper and other combustible materials. Never touch the tip or any metallic part near the tip when the unit is
switched on.
• Handle with care. The station contains delicate parts. Never drop the unit or submit it to shocks.
• Disconnect the unit from the mains when not in use or during long breaks.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
• Only use genuine replacement parts. Make sure the iron has sufficiently cooled before replacing.
• Work in a well-ventilated area as soldering produces vapours which may be toxic when inhaled.
• Lock the pump screw located at the bottom of the station before transporting to avoid damaging the unit.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• Keep the device away from children and unauthorised users.
• Incorrect use of this tool may cause fire.
• Be cautious when using this tool in places where inflammable products are stored.
• Heat can cause fire to inflammable products even when they are not in sight.
• Do not use the tool in an explosive atmosphere.
• Place the tool back in its stand in order to let it cool down before storage.
3. Use
CAUTION: Remove the securing pump screw (red M5 x 10) at the bottom of the station before
operating. Failure to do so will seriously damage the unit.
DESOLDERING
1. Connect the unit to the mains by means of the power cord and switch on the unit.
• Upon connection, the automatic blowing function will start blowing air through the pipe. The heating
element remains cool.
• By switching on the unit, the heating element will begin to warm up.
VTSS110_v2 2 VELLEMAN