Battery Maintenance; Recharging The Batteries; Setup - Orderman Don Mode D'emploi

Instructions for use
4

Battery Maintenance

4.1

Recharging the Batteries

Load the batteries into the hand-held unit and plug the power supply unit into
the bottom side of the ORDERMAN
are now being charged.
If the ORDERMAN
cated by the battery-charging symbol in the display.
A complete charging process takes 4 hours.
The unit can be used during the charging process.
You can also charge the batteries in the ORDERMAN
(optional). The charging process in the charging station takes 60 minutes.
Just follow the directions in the charging-station operating instructions.
A fully charged battery allows for an operating time of from 6 to 16 hours (de-
pending on the setting of the automatic shutoff and the backlighting – see page
22).
The number of recharging cycles for the ORDERMAN
1000 recharging cycles. The batteries then undergo a natural deterioration in
which the operating time becomes shorter.
With a short press on the DON touch-field (see page 17), the charg-
ing status of the batteries is indicated.
Tip
5

Setup

Before the initial setup, it is recommended that the batteries be fully charged
(see Battery Maintenance) as well as that a touch-calibration be performed (for
this, see page 21 – Setting the Touch Calibration).
To start the unit, load the charged battery pack and activate the On button.
After the hand-held unit has established radio contact with the POS Center, it
can be put immediately into service.
DON then into a power outlet. The batteries
®
DON is switched on, the charging process is indi-
®
20
Hand-held Unit
DON Charging Station
®
DON batteries is around
®