MRA KTM Super Adventure 1290/S Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
2 Lens head screws, M5x35mm
2 Lens head screws, M5x30mm
4 Washers 13x6 x0.5mm
2 Distance sleeves 25mm
2 Distance sleeves 20mm
4 O-rings 45x1.5mm
1 Edge protection strip with clamping
sleeves
Fitting the windscreen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Dismantle the original windscreen.
3. Insert the provided M5x35mm lens head screws [10632] with the plastic washers
[10669] into the upper holes on the MRA windscreen. Then insert the M5x30mm lens
head screws [10566] into the lower holes on the MRA windscreen.
4. Now apply the 25mm distance sleeves [10996] from behind onto the screws of the
upper hole. The 20mm distance sleeves [11181] must be applied to the lower holes.
Now the sleeves must be secured with the provided O-rings [10992] which act as
assembling aid.
5. Mount the MRA windscreen to your motorbike and tighten all four screws (P8).
6. Apply the protective edge strip profile as shown in the figure.
7. Push the clamping sleeves over the ends of the protective edge strip and lightly
compress them, using a pair of pliers to secure the protective edge strip profile.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
KTM Superduke 1290/S 2017-
Article No..
--- Torx 30
10632 Allen key 3mm
10566
10669
10996
11181
10992
---
3
Required tools