Vacation And Moving Care - Whirlpool GI15PDXZS Guide D'utilisation Et D'entretien

14. Slide the cutter grid back into place and secure it by replacing
the right-hand screw and plastic spacer. Then tighten the left-
hand screw. Reconnect the cutter grid harness and the ice
level sensor harness.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
To Shut Down the Ice Maker:
1. Unplug ice maker or disconnect power.
2. Remove all ice from storage bin.
3. Shut off the water supply.
4. Remove the 2 screws in the lower access panel and the 2
screws from the base grille area of the front panel support.
Pull forward to remove the lower access panel.
16
15. Replace the cutter grid cover.
16. Gently wipe the control panel with a soft, clean dishcloth
17. Plug in ice maker or reconnect power.
18. After cleaning, make sure that all controls are set properly and

Vacation and Moving Care

5. Disconnect the inlet and outlet lines to the water valve. Allow
6. Replace lower access panel and screws.
7. Drain water from water pan by removing the drain cap.
8. If the room temperature will drop below 32°F (0°C), water
9. Before using again, clean the ice maker and storage bin.
10. Plug into a grounded 3 prong outlet.
NOTE: All components of the ice maker are permanently
lubricated at the factory. They should not require any additional
oiling throughout the normal life of the machine.
using warm water and a mild liquid dish detergent.
that no control indicators are flashing.
these lines to drain and then reconnect to the valve.
must be removed from the drain line.
For Ice Makers with a Drain Pump Installed
Plug in ice maker or reconnect power.
■
Turn ice maker off and remove all remaining ice from ice
■
bin.
Pour 1 qt (0.95 L) of water into the ice bin near the drain
■
and let the ice maker stand for approximately 5 minutes.
This will allow the water in the bin to drain into the drain
pump so that the pump will remove the remaining water
from the ice bin and the drain pump.
Unplug ice maker or disconnect power.
■