MetaSystem Meta Voice Manuel D'installation page 10

FITTING THE BLUETOOTH HANDS-FREE KIT
Where to fi t the Metavoice control unit:
The Metavoice control unit should be fi tted under the dashboard or in any other place
within the seating area of the vehicle provided safe operation of the vehicle is not jeo-
pardized and it does not prove a hindrance for the driver or passengers.
It can be fi tted using screws and the two holes provided on the box, or by using adhe-
sive Velcro tape.
Be sure the position chosen for the wires in the Metavoice cable will not cause them
excessive wear (for example, running them underneath the seats or along sharp edges).
We recommend taping them down with black tape once the product has been fi tted
Do not fi t the module inside a closed metal housing or any place on the vehicle whe-
re radio frequency transmission may be hindered, as this could cause problems when
using the Bluetooth utility.
When fi tting the Bluetooth module, make sure the wires for the microphone and the
speaker are long enough to reach the positions where they are to be fi tted.
Where to fi t the Microphone:
The position of the microphone is essential for correct operation of the system.
The best place for fi tting the microphone is on the central courtesy light above the
windscreen.
Fitting the microphone directly on the windscreen is not recommended as interference
caused by wind noise is more noticeable.
10