Dmx-512 Connection / Connection Between Devices - Futurelight PRH-540-2 Mode D'emploi

Screw one clamp each via a M12 screw and nut onto the Omega-clamps.
Insert the quick-lock fasteners of the first Omega-clamp into the respective
holes on the bottom of the device. Tighten the quick-lock fasteners fully
clockwise. Install the second Omega-clamp.
CAUTION!
The load must always be installed in the centre of gravity!

DMX-512 connection / connection between devices

The wires must not come into contact with each other, otherwise
the devices will not work at all, or will not work properly.
Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the device or one device with another.
31/83 51837615_V_1_1.DOC