Induction Principle; Sensitive Touch; Starting-Up; Pan Detection - Novy Induction Comfort 1752-2 Mode D'emploi Et D'installation

Induction principle

An induction coil is located under each heating zone. When it is engaged, it produces a variable
electromagnetic field which produces inductive currents in the ferromagnetic bottom plate of the
pan. The result is a heating-up of the pan located on the heating zone.
Of course the pan has to be adapted:
• All ferromagnetic pans are recommended (please verify it thanks a little magnet): cast iron
and steel pans, enamelled pans, stainless-steel pans with ferromagnetic bottoms...
•
Are excluded: cupper, pure stainless-steel, aluminium, glass, wood, ceramic, stoneware,...
The induction heating zone adapts automatically the size of the pan. With a too small diameter
the pan doesn't work. This diameter is varying in function of the heating zone diameter.
If the pan is not adapted to the induction hob the display will show [ U ].

Sensitive touch

Your ceramic hob is equipped with electronic controls with sensitive touch keys. When your finger
presses the key, the corresponding command is activated. This activation is validated by a
control light, a letter or a number in the display and/or a "beep" sound.
In the case of a general use press only one key at the same time.

Starting-up

You must first switching on the hob, then the heating zone:
•
Start-up/ switch off the hob:
Action
To start
Touch the key
•
Start-up/ switch off a heating zone:
Action
Zone selection
Increase power
Decrease power
Stop
If no action is made within 20 second the electronics returns in waiting position.

Pan detection

The pan detection ensures a perfect safety. The induction doesn't work:
• If there is no pan on the heating zone or if this pan is not adapted to the induction. In this
case it is impossible to increase the power and the display shows [ U ]. This symbol
disappears when a pan is put on the heating zone.
•
If the pan is removed from the heating zone the operation is stopped. The display shows
[ U ]. The symbol [ U ] disappears when the pan is put back to the heating zone. The
cooking continues with the power level setted before.
After use, switch the heat element off: don't let the pan detection [ U ] active.

Residual heat indication

After the switch off of a heating zone or the complete stop of the hob, the heating zones are still
hot and indicates [ H ] on the display.
The symbol [ H ] disappears when the heating zones may be touched without danger.
As far as the residual heat indicators are on light, don't touch the heating zones and don't put any
heat sensitive object on them. There are risks of burn and fire.
Control panel
Press key [ ] for 2 sec.
Press key [ ] for 2 sec.
Control panel
Press [ ] from the zone
Press key [ + ]
Press key [ - ]
Press key [ - ] until 0
56
Display
[ 0 ]
Nothing or [ H ]
Display
[ 0 ]
[ 1 ] to [ 9 ]
[ 9 ] to [ 1 ]
[ 0 ] or [ H ]