Pairing The Wireless Switching Adapter With The Brematicpro Gateway; Factory Reset; Cleaning The Device; Troubleshooting - brennenstuhl SmartHome Mode D'emploi

Pairing the Wireless Switching Adapter with
the BrematicPRO Gateway
When linked with the Home Automation Systems BrematicPRO via
the BrematicPRO Gateway, you can use the app / BrematicPRO PC
software to use additional functions, e.g. timer control, theme control,
astro function (dawn / dusk control).
The app or BrematicPRO PC software is installed and open.
The BrematicPRO Gateway is ready for use.
Maintain a distance greater than 50 cm to the gateway. To ensure
optimal pairing.
Open the "Settings" menu.
Select the room where you wish to use the device.
Select "Add Device".
Select the frequency "868 MHz".
Under "New Device", select "Switch / Socket" or "Lighting" and
"Continue" to confirm your selection.
Follow the on-screen instructions.
Press and hold the Pair button on the device for 3 seconds.
Enter a device name, e.g. "Living Room Floor Lamp".
Select "Add" to assign the device to the room.
First tap "Back" to leave the room, then "Done" to complete
the pairing process.
The wireless switching adapter is now connected to the Home
Automation Systems BrematicPRO.
Use "Test Device" to switch the device on and off to ensure the
wireless switching adapter is working properly.
In this submenu you can also add the device to your favourites.
For more information about the app and how to use it, please visit:
www.brematic.com/en/service

Factory reset

The device can be restored to the factory settings at any time. A reset
will be required if malfunctions occur.
Press the Pair button for at least 6 seconds.
The LED will flash rapidly and go out after approx. 3 seconds.
The device has been reset.
Wireless switch adapter 868.3 MHz

Cleaning the device

DANGER! RISK OF ELECTRIC SHOCK.
Disconnect the device from the mains before cleaning.
Do not allow liquids to enter the device. Liquids entering can result in
a short circuit.
Clean the device with a dry, lint-free cloth. For tough dirt, you
may also slightly dampen the cloth.
To not clean with solvent-based cleaners. These could damage
the product surface and markings.
Never immerse the device in water or other liquids. The device
may otherwise be damaged.
Be sure the device is completely dry before using it again.

Troubleshooting

Problem Possible cause
LED doesn't flash. The device is not
properly connected
to the socket.
Device not The device is outside
detected. the gateway range.

Disposal

The packaging is made from environmentally-friendly
materials which can be disposed of through your local
recycling facilities.
Contact your local refuse disposal authority for more details of how to
dispose of your worn-out product.
To help protect the environment, please dispose of the
product properly when it has reached the end of its
useful life, not in the household waste. Please contact
your municipality for information on collection facilities
and their opening hours.

Service

For questions related to the product, please contact us at
www.brematic.com/en/service.
Tel.: 0080048720743 (toll-free)
Action
Connect the device to
the socket properly.
Verify the wall socket
is powered.
Reduce the distance
to the gateway.
EN 13