User Guide - Adax Neo Manuel D'utilisation

First time use and after power cuts of over
1
60 minutes
When putting Adax Neo into operation or after a
lengthy power cut, the display will flash, showing
that no temp. reduction programme is active. Press
"F" to reset and the thermostat will revert to the
default settings: 22°C for normal temp. and 15°C
for reduced temp. The duration of temp. reduc-
tion is 7 hours at night and 5 hours during the day.
Temp. reduction is not activated.
5 Set the correct day of the week
Cancel a period of temp. reduction
9
x1
12
NEO
Set the correct week-day by holding
down on "F" until "d" (d = day) is
shown in the display.
Press or until the appropriate
figure is displayed. Monday = 1,
tuesday = 2 etc. Store the setting by
pressing "F", or allow it to be stored
automatically after appr. 30
seconds.
NB! The correct weekday must
be set at a time later than the
start of daytime temp. reduction.
Hold down on "F" and press once
on "7" or "5" to override the
current active period, or the next
period of temp. reduction. The
lamp is lit steadily for the period
in question. Temp. reduction will
resume as usual from the
following period.
Select the normal temperature
2
setting
Choose the desired normal
temperature by pressing
What do flashing lights and steady
6
lights A and B indicate?
A
Slow flashing shows that a temp.
reduction period is ongoing. At the
same time the display will show the
temp. setting.
B
A steady light shows that Neo is pro-
grammed for temp. reduction, but that
it is not currently in an active period.
Delete a period of temp. reduction
10
Hold down on "7" or "5"
until the green lamp is
extinguished.

USER GUIDE

or .