Using Balance Adjustment; Adjusting Loudness; Adjusting Source Levels - Pioneer SUPER TUNER III FH-P4000 Mode D'emploi

Audio Adjustments

Using balance adjustment

You can select a fader/balance setting that pro-
vides an ideal listening environment in all occu-
pied seats.
1 Press to select
AUDIO
Press until
AUDIO FADER
play.
• If the balance setting has been previously
adjusted, will be displayed.
BAL
2 Press 5 or ∞ to adjust front/rear speaker
balance.
Each press of 5 or ∞ moves the front/rear
speaker balance towards the front or the rear.
• –
FADER :F25 FADER :R25
front/rear speaker balance moves from front to
rear.
• is the proper setting when only two
FADER : 0
speakers are used.
• When the rear output setting is subwoofer,
you cannot adjust front/rear speaker balance.
Refer to Switching the rear output setting on
page 40.
3 Press 2 or 3 to adjust left/right speaker
balance.
When you press 2 or 3,
Each press of 2 or 3 moves the left/right
speaker balance towards the left or the right.
• – is displayed as the
BAL :L25 BAL :R25
left/right speaker balance moves from left to
right.

Adjusting loudness

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press to select
AUDIO
Press until
AUDIO LOUD
.
FADER
appears in the dis-
is displayed as the
is displayed.
BAL : 0
.
LOUD
appears in the display.
2 Press 5 to turn loudness on.
appears in the display.
LOUD :ON
3 Press ∞ to turn loudness off.
appears in the display.
LOUD :OFF
Note
• You can also turn loudness on or off by press-
ing .
LOUD

Adjusting source levels

SLA (Source level adjustment) lets you adjust
the volume level of each source to prevent radi-
cal changes in volume when switching between
sources.
• Settings are based on the volume level of the
FM tuner, which remains unchanged.
1 Compare the FM tuner volume level with
the level of the source you wish to adjust (e.g.,
built-in CD player).
2 Press to select
AUDIO
Press until
AUDIO SLA
3 Press 5 or ∞ to adjust the source volume.
Each press of 5 or ∞ increases or decreases
the source volume.
• – is displayed as the source
SLA :+4 SLA :–4
volume is increased or decreased.
Notes
• Since the FM tuner volume is the control, it is
not possible to apply source level adjustments
to the FM tuner.
• The AM tuner volume level can also be
adjusted with source level adjustments.
• The built-in CD and the multi-CD players are
both set to the same source level adjustment
volume automatically.
.
SLA
appears in the display.
En
Section
08
33