Preliminary Checks; Electrical Pre-Equipment; Safety Instructions Relating To Installation - SOMFY HOME MOTION Ixengo L 230V RTS Manuel D'installation

Ixengo L 230V RTS

1.3 Preliminary checks

> installation environment
attention
Do not spray water onto the motorisation.
Do not install the motorisation in an explosive environment.
> Condition of the gate to be motorised
Do not motorise a gate which is in bad condition or
incorrectly installed.
Before installing the motorisation, check that:
the gate is in good mechanical condition
it can be manoeuvred easily with no points of resistance
the mountings for the gate are in good condition
the gate is not equipped with any manual or electric locking
system (unless compatible with the Somfy motorisation)
the points where the motorisation will be attached are
sturdy and in perfect condition.

1.4 electrical pre-equipment

> Cable feed
Underground cables must be equipped with a protective
sheath with a sufficient diameter to contain the motor cable
and the accessories cables.
For overground cables, use a cable grommet that will
withstand the weight of vehicles (ref. 2400484).

1.5 Safety instructions relating to installation

Ensure that any danger zones (crushing, cutting, trapping)
between the driven part and the surrounding fixed elements
caused by the opening movement of the driven part are
avoided or indicated on the installation (see the section on
risk prevention).
Modifying one of the elements provided in this kit or using
an additional element not recommended in this manual is
strictly prohibited.
Monitor the gate as it moves and keep people away from it
until installation is complete.
Do not use adhesive to secure the motorisation.
Manual back release device: see paragraph concerning
this device in the user manual for the motorisation.
Manual unlocking may result in uncontrolled movement of
the gate.
Installation of an active safety edge is compulsory.
2
Warning
Warning
Warning
Danger
After installation, ensure that:
- the mechanism is correctly adjusted
- the manual back release device is operating correctly
- the motorisation changes direction when the gate
encounters an object 50 mm high positioned halfway up
the leaf.
> Clothing precautions
Take off any jewellery (bracelet, chain, etc.) during
installation.
For manoeuvring, drilling and welding operations, wear
appropriate protection ( special glasses, gloves, ear
protection, etc.).
1.6 regulations
SOMFY declares that this product complies with the
essential requirements of applicable European directives.
A Declaration of Conformity is available at www.somfy.com/
ce (IXENGO L 230V RTS).
1.7 assistance
You may encounter difficulties or have questions when
installing your motorisation.
Do not hesitate to contact us; our specialists are on hand to
answer all your questions. Internet: www.somfy.com
Copyright © 2015 Somfy SAS. All rights reserved.