Closing The Door; Installation - Atag KF8178WDL/A01 Notice D'utilisation

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

INSTALLATION
Positioning
Warning! If you are discarding an old
appliance that has a lock or catch on
the door, you must ensure that it is
made unusable to prevent young
children being trapped inside.
Remove the lamp cover by
pressing it inwards with a
tool (e.g. screwdriver) to free
the rear side hookings.
At the same time, free the
middle hook and slide off the
cover in the direction of the
arrows.
Replace the used lamp with
a new lamp of the same type
and specifically designed for
household appliances and
having the same characteris-
tics.
Install the lamp cover.
Connect the mains plug to
the mains socket.
Open the door. Make sure
that the lamp comes on.
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Important! The appliance shall have the
plug accessible after installation.
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:
25