Closing The Door; Installation; Ventilation Requirements - Atag KA2411L Notice D'utilisation

26

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.

INSTALLATION

WARNING! Refer to Safety
chapters.
Positioning
Install the appliance in a dry, well ventilated
indoors where the ambient temperature
corresponds to the climate class indicated
on the rating plate of the appliance.
Cli- Ambient temperature
mate
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation
can only be guaranteed within
the specified temperature range.
If you have any doubts
regarding where to install the
appliance, please turn to the
vendor, to our customer service
or to the nearest Authorised
Service Centre.
Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
3. If necessary, replace the defective door
gaskets. Contact the Authorised
Service Centre.
rating plate correspond to your domestic
power supply.
• The appliance must be earthed. The
power supply cable plug is provided with
a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a qualified
electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the E.E.C.
Directives.

Ventilation requirements

The airflow behind the appliance must be
sufficient.
min.
5 cm
200 cm
CAUTION! Refer to the
assembly instructions for the
installation.
2
min.
2
200 cm