Possible Malfunctions; Technical Data - IKRA BHSN 602 Manuel D'utilisation

Possible malfunctions

Malfunction
Hedge trimmer does not run
Hedge trimmer cuts with
interruptions
Motor runs, but cutter remains
stationar
Cutter is hot

Technical data

BHSN 601 petrol-driven hedge trimmer
Max. motor power at speed........................................................ 0,9 kW bei 8.500 rpm
Capacity......................................................................................25,4 cm
Idling speed................................................................................ 3400 rpm
Ignition system............................................................................Electronic ignition
Spark plug...................................................................................NHSP L8RTF
Fuel tank capacity.......................................................................0,6 l
Mixing ratio (petrol/two-stroke oil)...............................................40:1
Cutting length............................................................................. 600 mm
Cutting........................................................................................ bis zu 27 mm
Weight (tank empty, blade guard removed)..................................6,1 kg
Sound pressure LPA (acc. to EN ISO 10517
Sound power level LWA (acc. to Directive 2004/108/EC)
Vibration (acc. to EN ISO 10517)
Technical changes are reserved.
GB | Operating instructions
Possible cause
• No fuel
• Fault in the fuel line
• Petrol filter blocked
• Spark plug defective
• Carburettor defective
• Internal fault
• Internal fault
• On/off switch defective
• Cutter jammed
• Internal fault
• Clutch defective
• Insufficient lubrication -- > Friction
• Insufficient sliding clearance
• Cutter is blunt
)..................................
............
13
Remedy
• Check the amount of fuel
• Check the fuel line for kinks or
damage
• Clean or replace the petrol filter
• Replace the spark plug
• Contact the manufacturer or a recom-
mended customer service centre
• Contact the manufacturer or a recom-
mended customer service centre
• Contact the manufacturer or a recom-
mended customer service centre
• Contact the manufacturer or a recom-
mended customer service centre
• Remove object
• Contact the manufacturer or a recom-
mended customer service centre
• Contact the manufacturer or a recom-
mended customer service centre
• Oil the cutter
• Adjust the sliding clearance
• Have the cutter sharpened
3
94 dB(A)
K = 2,5 dB
114 dB(A)
K = 3 dB
2
6,0 m/s