Container-Stop & Shelf-Stop-Position; Safety Stop - VITRA CDS Mode D'emploi

Container stop & shelf stop position
These two functions can be used in order to limit the move-
ment range of the seat / standing workstation.
A container stop position can only be set in the lower half of
the movement range, and a shelf stop position only in the
upper half of the movement range.
If a container stop position is set, this will be used as the
lower end position, while a shelf stop position corresponds
to the upper end position of the movement range.
To save a container or shelf stop position to memory:
1. Move the seat / standing workstation to the position which
you want to use as the new container or shelf stop position.
• UP / DOWN hand switch:
Now press the "Up" and "Down" buttons at the same time
for 10 seconds.
• COMFORT hand switch:
Now press the "Memory" button for 10 seconds
2. The save to memory procedure is confirmed by the con-
trol system with a double click tone.
To deactivate a container stop or a shelf stop position:
Move the seat / standing workstation to any position in the
lower half of the movement range, in order to deactivate
the container stop, or in the upper half of the movement
range for the shelf stop position.
• UP / DOWN hand switch:
Now press the "Up" and "Down" buttons at the same time
for 10 seconds.
• COMFORT hand switch:
Now press the "Memory" button for 10 seconds.
These steps must be carried out separately for the container
stop and the shelf stop position!

Safety stop

! DANGER!
In order to avoid injuries (e.g. crushing), your control system
is fitted with a safety stop.
On reaching a height of 74 cm, there is a notable reduction
in movement speed.
Saving table top positions in the safety zone is not possible.
EN
23